Arc Sub 7/22/98 2:56 PM Page 4
three.Operation
ModeProcedureLED Status
OffReceiver/amplifier offRed
OnReceiver/amplifier on and playing program materialGreen
StandbySimply turn off your receiver/amplifier. The subwoofer willRed
turn off after approximately five minutes. The subwoofer
will turn on when your receiver/amplifier begins playing again.
Volume
Crossover Frequency
The crossover frequency knobthis adjustment to find thebeing sent to your satellite
determines the highest fre-crossover frequency thatspeakers. This means that
quency your subwoofer willsounds best with your your satellites wonOt have
reproduce. It allows a seam-speakers. When using theto try and reproduce the
less transition from thespeaker-level connections,information the subwoofer
subwoofer to the satellitethe crossover adjustment willis playing.
speakers. Experiment withalso limit the low frequencies
Troubleshooting
If you used the high-levelIf there is low bass output,If you used the line-level
(speaker) inputs and therecheck the following:inputs and there is no
is no sound from any of theY Make sure the connectionssound from the subwoofer,
speakers, check the to the left and right OSpeakercheck the following:
following:Inputs� have the correctY Receiver/amplifier is on
Y Receiver/amplifier is onpolarity (+ and �).and a source is playing.
and a source is playing.Y Make sure that the sub-Y Powered subwoofer is
Y Powered subwoofer iswoofer is plugged into anplugged in.
plugged in.active electrical outlet.Y Check all wires and con-
Y Check all wires and connec-Y Powered subwoofer isnections between receiver/
tions between receiver/plugged in.amplifier and subwoofer.
amplifier and speakers. MakeY Adjust the crossover point.Make sure all wires are con-
sure all wires are connected.nected. Make sure none of
Make sure none of thethe wires is frayed, cut, or
speaker wires is frayed,punctured.
cut, or punctured.Y Review proper operation of
Y Review proper operation your receiver/amplifier.
of your receiver/amplifier. |